release emergency stop push button Flush Flat Emergency Stop Start Waterproof Switch
How to wire the emergency stop switch?
Just connect the normally closed point of the emergency stop switch to the control circuit (connector coil) of the connector in series! Pressing a few buttons will open the closed point of the emergency stop, which also disconnects the circuit of the connector coil and contacts Stop the work and cut off the main circuit! Use a connector to measure the emergency stop switch. If it is open when you don’t press it, it will be closed! Your connector has L1 —- L6 is the main circuit if it is marked with K1, K2, the two contacts at the bottom are the coils of the connector and you can see that they are wired into the internal, but you can’t connect it, it’s better to find someone to fix it!
How to use an emergency stop switch?
Precautions for the use of emergency stop button switches: In industrial safety, it is required that all machines whose transmission parts directly or indirectly cause harm to the human body under abnormal conditions must be protected. The emergency stop button is one of them. Therefore, the emergency stop button must be added when designing some machines with transmission parts. And it should be set on the surface of the machine that can be easily pressed by personnel, and there should be no obstructions. The emergency stop button switch can be directly pressed down to quickly stop the whole equipment or release some transmission parts. If you want to start the device again, you must release this button, that is, you only need to rotate it clockwise about 45° and then release it, and the pressed part will pop up. That is to “release”.